Interior demolition in Halton Hills
Deep downtown lots take a compact machine to the back; rural lots take anything; the drive from the yard is the long part. Dust walls up, the stair protected, every finish and partition out, and the joists and studs swept and photographed at handover. Interior demolition is the house gutted and the shell left standing, the first trade on any whole-house renovation.
Halton Hills, on the ground.
Georgetown and Acton have century cores and 1980s to 2000s subdivisions, with farms and barns on the concession roads between them. That tells us what the walls are made of and how many layers of floor are waiting under the carpet. Basement and kitchen strip-outs in the subdivisions, additions in the old cores, barn removals in the country.
Read more about demolition in Halton Hills or the full interior demolition service page.
On the ticket.
Whole-house containment: dust walls, sealed HVAC, protected stair and exterior doors
Water and power isolated by licensed trades; services to stay marked and protected
Drywall, plaster and lath, ceilings, insulation, flooring and underlayment out
Kitchens, bathrooms, closets, built-ins, doors and trim removed
Non-structural partitions out; load-bearing walls left or removed under the structural scope
Nails pulled, joists and studs swept, photos of every room at handover
Paper first.
Gutting a house is non-structural and usually needs no permit; the renovation that follows does, and any load-bearing wall needs an engineer. The Town of Halton Hills issues the permit; escarpment-area lots can need approvals beyond the Town's. [Kam confirms.]
- Gutting a house to the studs is non-structural and usually needs no demolition permit. The renovation that follows needs a building permit.
- Any load-bearing wall, stair or floor opening is structural: permit, engineer's drawing and temporary shoring.
- Pre-1990 houses: a designated-substances survey comes first (O. Reg. 278/05). Plaster, floor tile, vermiculite and pipe insulation are the usual finds.
- Multi-unit conversions and second suites need a building permit and, in some municipalities, zoning approval before the finish goes in.
The plates on every truck: WSIB, insurance, demolition permits, asbestos survey, utility locates, crew training.
| Driver | What we look at |
|---|---|
| Floor area and storeys | Square footage over every floor coming out. |
| Walls and floors | Plaster and lath and three layers of flooring take longer than drywall and one. |
| Access | Hand-carry to a street bin adds labour on every load. |
| Bins and tipping | Bin count by weight. |
| Permit and utility locates | Whether a permit applies and whether we book the locates. |
The number comes from a site walk. Plaster and lath, three layers of flooring and hand-carry to a street bin move it up; the walk accounts for all three.
Not for the strip-out if nothing structural comes out. The renovation that follows needs a building permit from the Town of Halton Hills.
About a week for a typical two-storey with a crew, less for a bungalow, more where there is plaster and lath. [Kam confirms.]
Yes. Properties inside the Niagara Escarpment Plan area may need approvals beyond the Town's; we flag it at the site walk. [Kam confirms.]